Troubleshooting - Eneo VKC-1330IR12-24 Mode D'emploi

EFFECT
D-ZOOM
NEGA/POSI
B/W
MIRROR
PIP
FREEZE
Note
PRESET SYNC
INIT
LOAD
SAVE
DNR
Note

8. Troubleshooting

If problems occur, verify the installation of the camera with the instruction in this manual and with other operating
equipments.
Isolate the problem to the specific piece of equipment in the system and refer to the equipment manual for further
information.
Problem Possible solution
No video
1. Verify power to all pieces of equipment in the system. The camera LED should be ON.
2. Verify that the video cable is connected correctly.
3. Verify that the lens cap has been removed from the lens or that the ids of the lens
Videos, but no control
1. Power down the system for one minute, then re-apply power.
Dark Video
1. Adjust iris
2. Check A/I connections
All manuals and user guides at all-guides.com
Activation / deactivation of the digital zoom function
Switches between negative and positive display.
Selection of colour or b/w picture.
Selection of right, left, reverse picture
Picture in picture
Select real and still picture
Freeze mode is automatically off, when zoom and focus
operation.
Internal (INT), line lock (L/L) or AUTO mode.
Sync phase is adjustable in line lock mode
Initializes camera (factory preset) PRESET/DEFAULT.
Sets camera to default settings (factory preset), FACTORY/
PRESET
To store settings (power line interrupt) the programming
has to be saved here.
Digital noise reduction mode on/off
In the Enhanced Dyamic Range or Low-Shutter mode,
image quality can be decreased. DIS is operated on digital
zoom x2. DNR is disabled in freeze,
Low-Shutter and WDR mode. WDR is not effective in freeze
status.
is open.
26
OFF
OFF
OFF
OFF
OFF
OFF
INT
Preset
Default
Preset
OFF