Motorola i500plus Manuel De L'utilisateur page 6

All manuals and user guides at all-guides.com
Molded In-Line
Fuse Holder
Adapter
Red Lead
Red Lead
Firewall
Grommet
Black Lead
Engine
Compartment
Figure 2. Power Cable Assembly
4. Cut the black lead to the desired length and connect it to the chassis
of the vehicle.
It is not good practice to connect the black lead to the
NOTE:
negative (-) battery terminal; the Car Kit could be
damaged if there were a malfunction in the vehicle's
electrical system.
5. Connect the red lead to an ignition-switched power source as fol-
lows:
a. Cut the long red lead to the desired length and connect (crimp) it
to the plug on the 2 ft. (60 cm) red fused section that was set
aside in step 3.
b. Connect the red lead from the fuse holder to a fused, switched
side of the vehicles ignition circuit.
Note: An ignition switched accessory terminal can be verified by
measuring the terminal while operating the vehicle's key switch.
With the ignition key switch in the accessory-ON position, the ter-
minal voltage should measure the vehicle's battery voltage. With the
switch in the OFF position, it should measure near zero.
6. Dress the cable in the engine compartment so that it does not
obstruct any vehicle controls nor touch any hot or moveable parts of
the engine.
7. Plug the fuse into the in-line fuse holder.
6 CAR KIT OWNER'S MANUAL
Fuse
Cover
Red Lead
Mounting
Hole
To Ignition -- Switched Circuit
To Vehicle
Chassis Ground