Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
All manuals and user guides at all-guides.com
•
If it is necessary to penetrate the firewall, check opposite side for
cable clearance before drilling and use a grommet to protect the
cable where it passes through.
Recommended Tools
The following tools are recommended for proper installation of your Car
Kit.
•
Portable Drill
•
Hammer
•
Center Punch
•
Phillips #2 Screwdriver
DC Power Cable Installation Instruction
The Car Kit must be operated only in negative ground electrical systems.
Reverse polarity (positive ground) does not damage the Car Kit, how-
ever, protection circuits cause the cable fuse to open. Check the ground
polarity before you begin installation to prevent wasted time and effort.
Both 12V and 24V electrical systems are supported.
The DC power cable shipped with the Car Kit is long enough for installa-
tion in most vehicles. Begin the power cable installation in the following
manner.
1. Remove the 5-ampere fuse from the power cable's red wire before
proceeding.
2. Allow sufficient slack in the power cable's connector end to reach
the end of Car Kit. (see Figure 1).
3. Set aside the 2 ft. (60 cm) fused section of the main power cable's
red lead for later use. Route the red and black leads of the main
power cable to convenient chassis ground and ignition line connec-
tion points. If it is necessary to penetrate the firewall, use an existing
opening or, if necessary, drill a 19/32 inch (1.5 cm) hole. Insert a
grommet into the hole to prevent damage to the power cable (see
Figure 2).
CAR KIT OWNER'S MANUAL
5
Publicité
Table des Matières
