emerio CME-123551.1 Mode D'emploi page 7

4. Now place the thermos jug on the tray of the appliance.
5. Plug the power cord into an appropriate outlet. The LCD will display the default time "AM 12:00" and the
colon in the middle will flash. You can press hour setting button and minute setting button to set the
current time. Each press changes one hour/minute. The time cycle is 12 hours.
6. Start brewing coffee by pressing the ON/OFF button once. The working indicator light will illuminate then.
The lid of the thermos jug needs to be closed in order to unlock the drip stop function.
7. When brewing finished, 3 buzzer sounds are sent out and the unit will be automatically shut off. You can
manually press the ON/OFF button again to switch on the appliance.
Note: The appliance is designed with an Anti-drip function. You can temporarily remove the thermos jug and
pour out coffee during brewing cycle without coffee dripping from the appliance within 30 seconds.
DELAYED BREW FUNCTION
If you do not want the coffee maker to start operation immediately, for example now it is 8:10 am, you hope
that the coffee maker will automatically start at 1:10 pm, first follow steps 1 to 5 of above section, and then you
can set the delayed brew function as follows:
1. Press the program setting button once, the default time and the delayed-brew indicator light will flash for
several seconds.
2. Press the hour/minute setting buttons continuously to set the delayed start time, which is 1:10 pm.
3. Press the program setting button once again. The LCD switches back to the current time, and the flashing
delayed-brew indicator light turns off.
4. Long press the program setting button for about 4 seconds to initiate the delayed brew. The delayed-brew
indicator light illuminates still. The LCD will show back the current time.
Note:
•
After the delayed brew is set, you may cancel the delayed brew by pressing program setting button once,
or pressing the ON/OFF button once to start brewing immediately.
•
If you need to change the delayed start time midway, you have to press program setting button first to exit
from the delayed brew function and then press the program setting button again to reset the time.
Descaling:
•
Regularly descale the coffee maker. The intervals of descaling depend on the water hardness and frequency
of operation. In case of average water hardness we suggest descaling every 3 or 4 months. Please use a
commercially available decalcification agent.
•
Fill 400 ml of water into the reservoir and add the necessary amount of decalcification agent in accordance
with the dosing instructions.
•
Let the decalcification agent sink in the coffee maker for about one hour. Switch on the unit after one hour
and let the water pass through. After that you should brew water several times and rinse all detachable
components, in order to clean off any residue.
CLEANING AND MAINTENANCE
•
Before cleaning remove the mains plug and let the device cool down.
•
Never immerse the device in water. Please use a slightly damp cloth to clean the surfaces.
•
Avoid using acrid or scrubbing cleaning agents.
•
Keep the coffee maker in a dry place out of reach from children when cooled off and cleaned.
•
Do not wrap the cord around the device.
TECHNICAL DATA
Operating voltage: 220-240V ~ 50-60Hz
Power: 900W
- 6 -