Belt Replacement - Hoover Uline H-3956 Mode D'emploi

FILTER BAG REPLACEMENT CONTINUED
CHANGING THE FILTER BAG
1. Push down at top of bag door,
pull door forward and remove
door. (See Figure 24)
2. Grasp filter bag collar (U)
and pull collar from tube (V).
(See Figure 25)
NOTE: Do not clean out
old filter bag and reuse.
Discard used filter bag.
3. To install new filter bag, align
opening in filter bag collar
with tube. Push bag firmly onto
tube. Tuck in filter bag.
4. Replace bag door by placing
tabs on bottom of door into
opening (W). (See Figure 26)

BELT REPLACEMENT

The vacuum's belt causes the
agitator brush roll to rotate and is
important for the vacuum to be
effective. The belt is located under
the bottom plate and should be
checked from time to time to be
sure it is in good condition.
1. Place the handle in the low
position and turn the vacuum
over so bottom side is up.
2. Unscrew the four screws (CC)
with a Phillips screwdriver. Lift
off the bottom plate (DD).
(See Figure 27)
3. If the belt is stretched, cut or
broken, replace immediately.
4. Remove agitator brush roll and
used belt. Discard used belt.
(See Figure 28)
5. With lettering on outside of
the new belt (EE), slide the belt
over the motor pulley (FF).
(See Figure 29)
6. Insert agitator brush roll through
belt and place belt in belt
guide (GG) on agitator.
(See Figure 30)
PAGE 6 OF 15
MAINTENANCE CONTINUED
Figure 24
Figure 25
V
U
Figure 26
W
Figure 27
DD
CC
Figure 28
Figure 29
EE
FF
Figure 30
GG
NOTE: If the agitator shield
(hh) becomes dislodged
while replacing the belt
or the agitator brush roll,
reposition below the belt
guide. (See Figure 30)
7. Grasp agitator brush roll firmly
and slide the end opposite of the belt into the
rectangular slot (HH) on the side of the vacuum.
Pull other side of agitator brush roll into place.
(See Figure 31)
8. Turn agitator brush roll to ensure belt moves freely.
9. Replace the bottom.
CLEANING SECONDARY AND FINAL FILTERS
SECONDARy FILTER
The secondary filter protects the motor from dirt particles.
It is located behind the grill in the bottom of the bag
compartment.
1. Pull off grill (X) and lift filter out
of compartment.
(See Figure 32)
2. Hand wash filter in cold water
with mild detergent, then air dry.
3. Replace filter and grill.
FINAL FILTER
The final filter assists in the filtration
process to return clean air to the
room.
1. Remove bag door and pull
down top of filter and lift out of
compartment. (See Figure 33)
2. Hand wash filter in cold water with mild detergent.
Air dry before replacing.
NOTE: Do not operate vacuum without either
secondary of final filter in place.
EDGE GROOMER REPLACEMENT
Replace the edge groomers, located on both sides of
the nozzle, when they appear worn.
1. Place handle in low position
and turn vacuum over. Using a
Phillips screwdriver remove the
four screws (S) on the bottom of
the vacuum. (See Figure 34)
(Edge groomer replacement
continued on page 7)
Figure 31
HH
Figure 32
X
Figure 33
y
Figure 34
S
0514 IH-3956