Carton Contents; Attach Handle - Hoover Uline H-3956 Mode D'emploi

This appliance must
be grounded. If it
should malfunction
or breakdown,
grounding
reduces the risk
of electric shock.
This appliance
is equipped with
a cord having
an equipment-
grounding conductor and grounding plug. The plug
must be inserted into an appropriate outlet that is
properly installed and grounded in accordance with all
local codes and ordinances.
WARNING! Improper connection of the
equipment-grounding conductor can result in
a risk of electric shock. Check with a qualified
electrician or service person if you are in doubt
as to whether the outlet is properly grounded.

CARTON CONTENTS

Unpack carton contents and identify parts.
A
B
A. Handle section
B. Vacuum body
C. Hose, cleaning tools and wands
D. Bolts x 2
E. Nuts x 2

ATTACh hANDLE

NOTE: Switch above bag door should be in OFF
position.
1. Remove bag door on vacuum
body by pushing down at
top of door and pulling door
outward. (See Figure 1)
PAGE 2 OF 15
SAFETY CONTINUED
GROUNDED
OUTLET
GROUNDING PIN
GROUNDED OUTLET BOX
C
Figure 1
WARNING! Do not modify the plug provided with
the appliance. If it will not fit the outlet, have a
proper outlet installed by a qualified electrician.
This appliance is for use on a nominal 120-volt
circuit and has a grounding attachment plug
that looks like the plug illustrated in the sketch.
Make sure that the appliance is connected
to an outlet having the same configuration as
the plug. No adapter should be used with this
appliance.
WARNING! Brush roll continues to turn while
product is turned on and handle is in upright
position. To avoid damage to carpet, rugs and
flooring, avoid tipping vacuum or setting it on
furniture, fringed area rugs, or carpeted stairs
during tool use. Do not use sharp objects to
clean out hose as they can cause damage.
Avoid picking up hard, sharp objects with this
product as they may cause damage. Store
in a dry place. Do not expose machine to
freezing temperatures.
ASSEMBLY
2. Slide handle onto vacuum
body. (See Figure 2)
3. Push bolts into holes on back of
D E
handle. (See Figure 3)
4. Place nuts in recessed areas on
front of handle. Hold each nut
in place while tightening each
bolt securely with a Phillips
screwdriver. (See Figure 4)
5. Reposition bag door by fitting
tabs on bottom of door into
opening. Press top of door
securely shut. (See Figure 5)
Figure 2
Figure 3
Figure 4
Figure 5
0514 IH-3956