Taymor PREMIER SQUARE ROSE Instructions D'installation

INSTALLATION INSTRUCTIONS FOR
PREMIER SQUARE ROSE KIT
PRIVACY/PASSAGE KIT INCLUDES:
INTERIOR ROSE BRACKET
PRIVACY
ONLY
INTERIOR ROSE COVER
EXTERIOR ROSE BRACKET
PRIVACY
ONLY
EXTERIOR ROSE COVER
DUMMY KIT INCLUDES:
ROSE COVER
COUNTERSUNK HOLE
ROSE BRACKET
THE FOLLOWING STEPS SHOULD BE OBSERVED TO PROLONG THE FINISH ON YOUR LOCKS
A) Do not install locks before doors are painted.
B) To avoid oxidation, refrain from using cleansers or acid chemicals to clean or polish.
C) Refrain from using heavy or sharp-edged objects to clean locks.
INTERIOR SIDE
COUNTERSUNK HOLE
1. Remove interior handle, existing rose cover and one of the mounting screws.
2. Place interior rose bracket over the base, aligning the countersunk hole on the
bracket with the empty screw hole. Reinstall the mounting screw removed in step 1.
3. Place square rose cover over the bracket, align horizontally and reinstall the handle.
EXTERIOR SIDE
4. Remove exterior handle and existing rose.
5. Place exterior rose bracket over the base aligning guides into holes.
6. Place square rose cover over the bracket and reinstall the handle.
ROSE BRACKET
INTERIOR
ROSE COVER
HANDLE
SET SCREW
COUNTERSUNK HOLE
BASE
ROSE BRACKET
ROSE COVER
SET SCREW
EXTERIOR
BASE
COUNTERSUNK HOLE
MOUNTING SCREWS
1. Remove handle, existing rose cover, and top mounting screw.
2. Place rose bracket over the base aligning countersunk hole with
the screw hole at the top of the base. Reinstall the mounting screw
removed in step 1.
3. Place square rose cover over the bracket and reinstall the handle.
TOP MOUNTING SCREW
SET SCREW
ROSE COVER
ROSE BRACKET
BASE
HANDLE
QUESTIONS:
CUSTOMER SERVICE
1-800-267-4774
WEST
1-800-387-7064
EAST
www.taymor.com
APR. 2015