Télécharger Imprimer la page

Publicité

Les langues disponibles

Les langues disponibles

4.3 FCC Statement

FCC Class A Radio Frequency
This equipment has been tested and found to comply with the limits for a Class
A digital device, pursuant to 1/47 CFR Part 15.109 Class A of FCC rules.
Operation is subject to the following two conditions:
1. This device may not cause harmful interference and
2. This device must accept any interference received, including interference that
may cause undesired operation.
The limits of FCC Part 15 class A are designed to provide reasonable protection
against harmful interference in residential installation. This equipment
generates, uses, and can radiate radio frequency energy and, if not installed
and used in accordance with the instructions, may cause harmful interference to
radio communications. However, there is no guarantee that interference will not
occur in aparicular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by turning
the equipment off and on, the user is encouraged to try to correct the
interference by more of one or more of the following measures:
1. Reorient or relocate the receiving antenna.
2. Increase the separation between the equipment and receiver.
3. Connect the equipment into an outlet on a circuit different from that to which
the receiver is connected.
4. Consult the dealer or an experienced radio/television technican for help.
Notice 1: The changes or modifications not expressly approved by the party
responsible for compliance could void the user's authority to operate the
equipment.
Notice 2: Shielded interface cables, if any, must be used in order to comply with
emission limits.
All manuals and user guides at all-guides.com
Test to Comply
With FCC Standards
For industrial use
TPI-8 / TPI-12 Touch Panel
75

Publicité

loading

Ce manuel est également adapté pour:

Tpi-12