Updating The Iris-Net Project File Or Application - IRIS Net TPI-8 Mode D'emploi

10. Choose the option Use the following IP address in the window.
11. Type the required IP address in the IP address input field.
12. Type the required subnet mask in the Subnet mask input field.
13. Type the required gateway in the Default gateway input field.
14. Close the window Internet Protocol (TCP/IP) Properties by clicking on
the OK button.
The network configuration of the TPI-8/TPI-12 is now complete.
15. Close the window Local Area Connection Properties by clicking on the
OK button.
16. Close the window Local Area Connection Status by clicking on the
Close button.
17. Close the window Network Connections.

Updating the IRIS-Net project file or application

The purpose of this procedure is to build a connection between a PC and a TPI-
8/TPI-12 with factory network settings (see page 11) and updating the IRIS-Net
project file or IRIS-Net application of the TPI-8/TPI-12. In the following it is
assumed that the file to be transfered is available at the PC.
1. Connect the network connection of your PC to the Ethernet interface
of the TPI-8/TPI-12 directly with a crossover cable, or with a patch
cable and a hub/switch.
2. Activate the power supply system of the TPI-8/TPI-12.
After some seconds a IRIS-Net project signals the successful start activity
of the TPI-8/TPI-12.
3. Click on Start > All Programs > Accessories > Command Prompt.
The window command prompt appears.
All manuals and user guides at all-guides.com
TPI-8 / TPI-12 Touch Panel
Owner's manual
15