IRIS Net TPI-8 Mode D'emploi page 5

15. Do not expose this equipment to dripping or splashing and ensure that no objects filled with liquids,
such as vases, are placed on the equipment.
16. To completely disconnect this equipment from the AC Mains, disconnect the power supply cord plug
from the AC receptacle.
17. The mains plug of the power supply cord shall remain readily operable.
Management of WEEE (waste electrical and electronic equipment) (applicable in
Member States of the European Union and other European countries with individ-
ual national policies on the management of WEEE) The symbol on the product or
on its packaging indicates that this product may not be treated as regular house-
hold waste, but has to be disposed through returning it at a Telex dealer.
CAUTION: These servicing instructions are for use by qualified personnel only. To reduce
the risk of electric shock, do not perform any servicing other than that contained in
the Operating Instructions unless you are qualified to do so. Refer all servicing to
qualified service personnel.
1. Security regulations as stated in the EN 60065 (VDE 0860 / IEC 65) and the CSA E65 - 94
have to be obeyed when servicing the appliance.
2. Use of a mains separator transformer is mandatory during maintenance while the
appliance is opened, needs to be operated and is connected to the mains.
3. Switch off the power before retrofitting any extensions, changing the mains voltage or the
output voltage.
4. The minimum distance between parts carrying mains voltage and any accessible metal
piece (metal enclosure), respectively between the mains poles has to be 3 mm and needs
to be minded at all times. The minimum distance between parts carrying mains voltage and
any switches or breakers that are not connected to the mains (secondary parts) has to be 6
mm and needs to be minded at all times.
5. Replacing special components that are marked in the circuit diagram using the security
symbol (Note) is only permissible when using original parts.
6. Altering the circuitry without prior consent or advice is not legitimate.
7. Any work security regulations that are applicable at the locations where the appliance is
being serviced have to be strictly obeyed. This applies also to any regulations about the
work place itself.
8. All instructions concerning the handling of MOS-circuits have to be observed.
NOTE:
All manuals and user guides at all-guides.com
IMPORTANT SERVICE INSTRUCTIONS
SAFETY COMPONENT
(MUST BE REPLACED BY ORIGINAL PART)
TPI-8 / TPI-12 Touch Panel
Owner's manual
5