Initial Operation; Editing Of Network Configuration - IRIS Net TPI-8 Mode D'emploi

2.3 Initial Operation

The TPI-8/TPI-12 can be connected to a TCP/IP-network via the Ethernet
interface at its rear panel (see page 8). The TPI-8/TPI-12 comes with the
following network configurations from the factory:
An IP address must be unique, it must only be allocated to one single device
(host) in a network. In case a new Ethernet network is designed for the
operation of the TPI-8/TPI-12, it is recommended to retain the subnet mask and
network ID which had been set at the factory. If the TPI-8/TPI-12 is integrated in
an existing Ethernet network, the network configuration of the TPI-8/TPI-12
must be adapted.
The preset IP address of the TPI-8/TPI-12 can be retained if and only if
• only a single TPI-8/TPI-12 with factory-set network configuration is con-
nected via Ethernet
• the network ID 192.168.1 can be retained and
• no other devices have the Host-ID 101.
If at least one of these three conditions is not fulfilled, the preset IP address of
the TPI-8/TPI-12 has to be changed.

Editing of network configuration

The purpose of this procedure is to build a connection between a PC and a TPI-
8/TPI-12 with factory network settings (see page 11) and editing the network
configuration (IP address, subnet mask, gateway) of the TPI-8/TPI-12. In the
following it is assumed that neither the PC nor the TPI-8/TPI-12 are connected
with an existing network, the power supply system of the TPI-8/TPI-12 is
deactivated.
All manuals and user guides at all-guides.com
Parameter
IP address
Subnet mask
Gateway
DHCP
Value
192.168.1.101
255.255.255.0
192.168.1.1
deactivated
TPI-8 / TPI-12 Touch Panel
11
Owner's manual