Before First Use; Daily Use; Stand-By Function - Electrolux EDE1074PDW Notice D'utilisation

32 www.electrolux.com

9. BEFORE FIRST USE

Before you use the appliance for the first
time do these operations:
• Clean the tumble dryer drum with a
moist cloth.

10. DAILY USE

10.1 Start a programme without
delay start
1. Prepare the laundry and load the
appliance.
CAUTION!
Make sure that when you
close the door, the
laundry does not catch
between the appliance
door and the rubber seal.
2. Set the correct programme and
options for the type of load.
The display shows the programme
duration.
3. Press the Start/Pauze (Start/Pause)
touchpad.
The programme starts.
10.2 Starting the programme
with delay start
1. Set the correct programme and
options for the type of load.
2. Press the delay start button again and
again until the display shows the delay
time you want to set.
You can delay the start of
a programme from a
minimum of 30 minutes
to a maximum of 20
hours.
3. Press the Start/Pauze (Start/Pause)
touchpad.
The display shows the countdown of the
delay start.
When the countdown is completed, the
programme starts.
10.3 Change a programme
1. Turn the Programme knob to
2. Set the programme.
All manuals and user guides at all-guides.com
• Start a short programme (e.g. 30
minutes) with moist laundry.
10.4 At the end of the
programme
When the programme is completed:
• The indicator
• An intermittent acoustic signal operates
(If the Buzzer function is on).
• The indicator Filtre (Filter) comes on.
• The Start/Pauze (Start/Pause) indicator
is on.
The appliance continues to operate with
the crease guard phase for approximately
other 30 minutes.
The crease guard phase removes creases
from your laundry.
You can remove the laundry before the
crease guard phase is completed. We
recommend, for better results, that you
remove the laundry when the phase is
almost completed or completed.
When the crease guard phase is
completed:
• The indicator
flash.
• Start/Pauze (Start/Pause) indicator
goes off.
1. Turn the Programme knob to
2. Open the appliance door.
3. Remove the laundry.
4. Close the appliance door.
Always clean the filter when a
programme is completed.

10.5 Stand-by function

To decrease the energy consumption, this
function automatically deactivates the
appliance:
OFF
• After 5 minutes if you do not start the
programme.
flashes.
is on but does not
OFF