Electrolux EDE1074PDW Notice D'utilisation page 38

38 www.electrolux.com
WARNING!
It is important not to connect
the vent hose to, for example,
a cooker hood, or a chimney
or flue pipe designed to
transmit the exhaust from a
fuel burning appliance.
Note that to prevent condensation
problems, it is essential that the dryer be
installed with the flexible hose to transmit
its "exhaust" at least beyond the kitchen
units; preferable outside the kitchen. In
order to prevent the appliance from
overheating, it is important that the steam
exhaust is unobstructed. Thus, if a
permanent hose installed to an external
wall or ceiling, it must be ensured an
exhaust capacity of minimum 150 m3/h. If
the dryer is installed adjacent to kitchen
units, make sure that the vent hose is not
squashed. If the hose is not fully
squashed, drying efficiency will be
decreased , resulting in longer drying
times and higher energy consumption. If
the hose is fully squashed, the automatic
cut-outs with which the appliance is fitted
can operate. When operating the tumble
dryer, the room temperature must not be
lower than +5°C and higher than +35°C,
as it can affect the performance of the
appliance.
All manuals and user guides at all-guides.com
If the hose is long and the
room temperature low, the
moisture might condense to
water inside the hose. This is
an usual occurrence. To
prevent this water from the
hose, it is recommend to drill
a small hole (via. 3 mm) in the
lowest point of the hose and
to put a small container
below it. (See picture, point
B).
Installation
There are 3 vent outlets: on
the left, right side and at the
rear.
1. Pull the ring nut A from the vent outlet
at the rear.
2. Screw on the ring nut to the hose and
push it into position.
B
A A