Warnings; Cautions - IDEAL 61-547 Instructions

Arc Flash and Shock Hazard, Proper PPE Required. Follow all safety procedures,
wear proper PPE in accordance to NFPA 70E and follow the guidelines below and
the instructions in this manual when operating the meter. Failure to comply can
result in serious injury or death.
• Have the Meter serviced only by qualified service personnel.
• Do not use the Meter around explosive gas, dust, or vapor, or during
electrical storms, or in wet environments.
• When measuring, keep fingers behind the Tactile Barrier. See "The
Meter" on pg. 8 and 9.
• Do not apply more than the rated voltage, as marked on the Meter,
between the terminals or between any terminal and earth ground.
• Voltages exceeding 30VAC or 60VDC pose a shock hazard so use
caution.
• Always ensure that test leads are secured so that they cannot be
accidentally snagged or tripped over.
• Do not work alone so that assistance can be rendered in an emergency.
• Use extreme caution when working around bare conductors or bus bars.
Contact with the conductor could result in electric shock.
• Adhere to local and national safety codes. Individual protective
equipment must be used to prevent shock and arc blast injury where
hazardous live conductors are exposed.
• These meters are IP42 dust & water resistant. Following any contact with
water, thoroughly dry meter and test leads prior to subsequent use.
•
Meter damage, equipment under test damage or data loss can occur
if the following guidelines are not adhered to.
• Use the proper terminals, function, and range for the measurement
application.
• Clean the case and accessories with a damp cloth and mild detergents only.
Do not use abrasives or solvents. Make sure the meter is completely dry
before use.
Cancer and Reproductive Harm - www.P65Warnings.ca.gov
WARNING
CAUTION
6