Operating Features; Using Test Leads - IDEAL 61-547 Instructions

Operating Features

High Voltage Warning (HI-V)
The meter indicates PPE by showing a PPE warning on the meter face. When
measuring >36V AC on the VAC function and >36V DC when on the VDC function.

Using Test Leads

Follow all safety procedures, wear proper PPE in accordance to NFPA 70E and
follow the guidelines below and the instructions in this manual when operating
the meter with the integral test leads. Test Leads must be rated for the electrical
environment the meter is being used in and have a voltage rating of at least the
voltage of the circuit to be measured. Failure to comply can result in serious injury
or death.
• Choking Hazard, Small Parts. Keep Away from Children. Sharp
Objects Hazard, This is not a toy. It is not for use or play by children. Keep
Away from Children. Failure to do so can result in serious injury.
• These meters are IP42 dust & water resistant. Following any contact with
water, thoroughly dry meter and test leads prior to subsequent use.
1. Use only approved test leads. Do not use improvised connections that could
present a safety hazard.
2. Prior to using the test leads, inspect them carefully for damaged insulation,
exposed metal or bent probes. Check test leads for continuity. Do not use
leads if they appear damaged.
3. When using the probes, keep fingers behind the finger guards on the
probes.
4. Connect the common test lead before connecting the live test lead. When
disconnecting test leads, disconnect the live test lead first.
5. Always ensure that test leads are secured so that they cannot be accidentally
snagged or tripped over.
This meter has integral test leads. They are not replacable.The lead set must comply
with requirements for Overvoltage and Measurement Categories CAT III 600V.
WARNING: Arc Flash and Shock Hazard, Proper PPE Required.
WARNING:
10