Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
User Manual
EN
BF Hybrid
4.
Check to make sure the gas cylinder is at least 4 meters away and on the side where the
wind comes from.
5.
Open up the gas bottle's gas valve.
6.
Light the ignition burner.
Please note: keep as much distance as possible when igniting the practice extinguisher. Use the
igniter with an outstretched arm.
7.
Squeeze the gas hose handle (3), allowing gas to enter the practice extinguisher.
8.
Ignite the practice extinguisher by holding the ignition burner just above the practice
extinguisher burner (7).
9.
Extinguish the ignition burner.
Let op: als de BF Hybrid niet ontsteekt, draai de gaskraan dan direct dicht en neem contact op met
FireWare.
10.
You can now conduct a fire extinguishing exercise with foam, water, CO2, powder or air.
5.
Switching off
You can put out the flames by letting go of the squeeze handle. Also make sure you close the gas
bottle's gas valve once you are finished and squeeze the handle one more time to release any
pressure from the hose.
Always allow the fire extinguisher trainer to cool down for at least 20 minutes before you relocate it.
The gas hose can be disconnected and the equipment stored away once the BF Hybrid has cooled off
sufficiently. If you have used water, you can let this run out of the practice extinguisher by lifting this
up by the handle. The water can run off through the overflow holes on the other side.
16
BF Hybrid
www.FireWare.nl
Publicité
Table des Matières
