Setting The Password - Dometic PERFECTVIEW REC 400 Instructions De Montage Et De Service

All manuals and user guides at all-guides.com
REC400
Selecting 'stop recording' when the ignition is off
You can select the switch-off time under the menu item "Power Management", after
which the video recorder switches off automatically and ceases recording after the
ignition has been switched off. The length of the interval can amount to
0/30/60/90/120 minutes.
➤ Select the required sub-item (see chapter "Navigating through menus" on
page 14).
➤ Select the preferred interval using
➤ Confirm by pressing
Checking the firmware version
You can check the current firmware version under the menu item "Version".
I
NOTE
Start by checking the current firmware before performing an upgrade.
➤ Select the required sub-item (see chapter "Navigating through menus" on
page 14).
✓ The current version is displayed.
8.2

Setting the password

You can define a four-digit PIN number to password-protect access to the main
menu under the menu item "Password".
➤ Select the required sub-item.
➤ Use
or to select digits for the PIN.
➤ Use
or to select a particular digit within the PIN.
➤ Confirm the "Sure" message by pressing
Configuring alarm inputs
You can make the settings for the alarm inputs under the menu item "Alarm".
Each alarm input can be allocated to each camera input. Two alarm inputs can be
allocated to the same camera input.
The alarm inputs feature priorities in descending order, from 1 to 4. In the event of
two simultaneous alarm impulses, the alarm input with the high priority is shown first,
with the respective channel being displayed.
EN
.
.
Setting the video recorder
.
17