Connecting The Video Recorder - Dometic PERFECTVIEW REC 400 Instructions De Montage Et De Service

All manuals and user guides at all-guides.com
REC400
7

Connecting the video recorder

➤ Connect the GPS antenna to the "GPS" connection (fig. 2 1, page 3).
➤ Connect the 12 V/24 Vg connection cable to the "Power In" connection
(fig. 2 2, page 3).
➤ Connect the 12 V/24 Vg connection cable as follows:
– yellow cable to the battery
– blue cable to the positive terminal (terminal 15)
– black wire to earth
If there is no optical contact between the internal infrared receiver on the video
recorder and the remote control, you will need to connect the external infrared
receiver:
➤ Connect the infrared receiver to the "IR" connection (fig. 2 3, page 3).
➤ If you are using the alarm function, you must connect the alarm cable to the
"Alarm In" connection (fig. 2 4, page 3) and to the signal generators.
If the camera connected features a mirror function, use the yellow cable of the
camera adapter cable for this. Depending on the camera model, the yellow cable
must be connected to earth or be left unconnected for the mirror function to be
activated, or deactivated.
If the yellow cable is left unconnected, insulate the end of the cable with insulating
tape or a shrink sleeve to prevent malfunctions.
➤ Use the adapter cable to connect the cameras to the "CAM1" to "CAM4" inputs
(fig. 2, page 3).
If your monitor does not feature RCA output sockets for the video and audio signal,
you will require an adapter.
➤ Connect the audio/video cable to the A/V output "A/V Out" (fig. 2 9, page 3)
and to the monitor.
➤ Connect the microphone to the "MIC" connection (fig. 2 10, page 3).
EN
Connecting the video recorder
13