Jenn-Air JB36SEFXRB Guide D'installation page 25

Door Height Adjustment (42" [106.7 cm] Models)
Use the following steps to adjust the door height, up or down,
after the refrigerator has been leveled.
NOTE: Adjust the right door to the position of the left door first. If
it is necessary to adjust the left door, you must make sure that the
hinged center rail located on the left-hand door does not drag
when closing the door.
1. Open the freezer drawer. Remove the locking plate screw
from the bottom side of the refrigerator door hinge using a
¹⁄₄" open-end wrench.
A B C
A. Bushing
B. Locking plate
C. Locking plate screw
2. Remove the locking plate as shown.
3. Turn the bushing located underneath the bottom of the hinge
using a ¹⁄₂" open-end wrench. Turning the bushing to the left
will lower the door. Turning the bushing right will raise the
door.
4. After adjusting, check the doors to make sure they are even
at the top and bottom. If the doors are not even, continue to
turn the bushing to adjust the door.
5. Replace the locking plate.
Turn the bushing slightly to align the hinge and locking
plate screw holes.
Replace and tighten the locking plate screw.
6. Make final check to make sure the doors are aligned and
even.
All manuals and user guides at all-guides.com
36" (91.4 cm) Models
1. Check that the refrigerator door can open freely. If the door
2. Hold the door open to a position that is less than 90°.
3. Replace the door stop screw in the bottom hinge and tighten.
42" (106.7 cm) Models
1. Check that the refrigerator door can open freely. If the door
2. Grasp both ends of the top grille.
3. Push the top grille straight up, then pull straight out. Lay the
†®TORX is a registered trademark of Saturn Fasteners, Inc.
Door Swing Adjustment
opens too wide, remove the door stop screw from the bottom
hinge with a Torx ®† T15 screwdriver.
A. Door stop screw
IMPORTANT: Do not place the door stop screw in the 130°
position on Overlay Series models. See "Handle and Door
Clearances."
A
A. 130°
B. 110° (Overlay series)
C. 90°
opens too wide, you will have to adjust the door stop
position.
grille on a soft surface.
B
A. Top grille
B. Cabinet side trims
A
B C
A B
25