Product Features; English | 7 - Bosch S 500 A PROFESSIONAL Instructions D'emploi

OBJ_BUCH-133-002.book Page 7 Tuesday, January 9, 2007 3:55 PM

Product Features

The numbering of the illustrated product features refers
to the representation of the drill stand on the graphics
page.
1 Insulated handle
2 Drilling column
3 Feed lock
4 Spirit level for vertical alignment
5 Spirit level for horizontal alignment
6 Upper locking handle on drill fixture
7 Lower locking handle on drill fixture
8 Drill fixture
9 Rack
10 Locking handle on depth stop
11 Depth stop
12 Drill-hole center indicator
13 Leveling screw
14 Supporting bracket
15 Knurled screw for supporting bracket
16 Hexagon screw for transport wheels
17 Transport wheels
18 Feed handle
19 Lock pin for feed feed handle
20 Lower locking handle for drill-angle adjustment
21 Angle scale
22 Lock button for drill-angle adjustment
23 Upper locking handle for drill-angle adjustment
24 Brickwork anchor*
25 Quick-clamping spindle*
26 Wing nut*
27 Sliding elements
28 Hexagon socket screws of the drill fixture
29 Adjusting screws of the drill fixture
*The accessories illustrated or described are not
included as standard delivery.
1 609 929 J56 • 9.1.07
All manuals and user guides at all-guides.com
Assembly
Mounting the Drill Stand
Supporting Angles
The supporting angles 14 can be mounted in two posi-
tions:
•
•
To switch between both positions, loosen the knurled
screws 15, adjust the supporting angles 14 to the re-
quired position and tighten them again with the knurled
screws.
Feed Handle
Press the lock pin 19 on the feed handle and keep it
pressed. Slide the feed handle 18 to the stop left or
right of the drill fixture 8 as required.
Release the lock pin 19 and check the feed handle for
tight seating.
Afterwards, block the feed: Pull the feed lock 3 upward
(A), turn it (B) and allow it to engage in position
required, lightly rotate the feed handle 18 until the lock
can be heard to engage.
Release the feed only for drilling: Pull the feed lock 3
upward (A), turn it (B) and allow it to engage in position
.
Transport Wheels
For transport of the drill stand, screw the transport
wheels 17 to the sides of the drill stand with the hexa-
gon screws 16.
The starting position (see Fig. A) is necessary when
the GDB 2500 WE is inserted into the drill stand and
the drill stand is not securely fastened with an
anchor, by vacuum or with a quick-clamping column.
The space-saving position (see Fig. B) is only possi-
ble when using the GDB 1600 WE/DE or when the
drill stand is securely fastened to the wall. Assembly
of the water collection ring (accessory) for the
GDB 2500 WE is not possible in this position.
3
3
. If

English | 7