Castel XELLIP Serie Manuel D'instructions page 16

AUDIO VIDEO IP WITH 1-6 PB DOOR ENTRY STATION
INSTALLATION
Flush mounting
Make a reservation 272mm high, 143mm wide and 65mm deep in the substrate.
Coat the bottom of the recess with at least 10mm of fresh cement.
Insert the base of the doorkeeper into the recess and push it in. Allow the base to protrude 2mm.
Allow the cement to dry for at least 24 hours, then connect the door.
Fix the front panel with the 6 FX (TORX) screws with M3 x 10 studs.
To guarantee a good seal for your intercom, it is necessary that the front panel, once mounted, presses on the whole
of the seal between the intercom and the door.
the entire seal between the back and the front panel.
Mounting on plasterboard wall
Create a recess 266mm high, 143mm wide in the wall.
Mount the clamping kit (Option ref. 590.9600) on the entry station base.
Set the entry station base in the recess using the clamps then connect the entry station.
Attach the front panel with the 6 FX teat screws (TORX) M3 x 10.
Technical data sheet no. 604-0090J
53
= =
142,5
= =
145
= =
2
60,5
www.castel.fr
= 55 =
53
= =
FR
EN
Page 16 / 24