Interacoustics Diagnostic Audiometer AD629 Instructions D'utilisation page 15

Masquer les pouces Voir aussi pour Diagnostic Audiometer AD629:
Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 45
Date: 2012-01-19
25
1 CD 2
26
Ext Range
27
Ch 1 Monitor 2
28
Talk Back
29
Right / Insert
30
Left / Insert
31
R Bone L
32
1 FF 2
33
Man / Rev
34
Single / Multi
AD629 Instruction for Use – English
By pressing this function once or twice it is possible to have
recorded speech in either channel 1 or channel 2 separately.
Adjust the gain of CD 1 and 2 by holding down the CD button for
one second.
Extended Range: Usually the maximum output is e.g. 100dB but if
a higher output e.g. 120 dB is needed then "Ext Range" can be
activated when reaching a certain level.
With the activation of this button, presentation to the patient from
e.g. CD can be heard through the built in monitor of the AD629 or
monitor headset in both channel 1 or 2. Adjust the gain by holding
down the button for one second.
Talk back, when active allows the clinician to hear comments or
responses from the patient through the AD629 or monitor
headset. Adjust the gain by holding down the button for one
second.
For selecting the right ear during testing. Insert phones for the
right ear can be activated by pressing twice.
For selecting the left ear during testing. Insert phones for the left
ear can be activated by pressing twice.
For bone conduction testing.
First push: selects the right ear for testing.
Second push: selects the left ear for testing.
Pressing "1 FF 2" will select free field speaker as output for
Channel 1.
First push: Free Field speaker 1
Second push: Free Field speaker 2
Manual / Reverse tone presentation modes:
First push: Manual tone presentation each time "Tone
Switch" (42) is activated.
Second push: The reverse function- continuous tone
presentation which will be interrupted each time "Tone
Switch" (42) is activated.
Pulsing modes:
First push: the tone presented will have a pre-set length
when "Tone Switch" is activated. (Set up in the
"Setup/Tests" (17)).
Second push: the tone will be pulsing continuously.
Third push: returns back to normal mode.
Page 11/17

Publicité

Table des Matières
loading

Table des Matières