Installation; Installing The Cabinet Feet; Installing The Door Handles; Door Position Adjustment - Conglom QL105 Manuel De L'utilisateur

Installation

INSTALLING THE CABINET FEET

CAUTION:
Do not rest or bump the leveling feet on the side
as this may cause them to detach or break .
- Remove the cabinet (A) and place it on a soft,
protective surface .
- Attach each cabinet leg (C) to the bottom of the cabinet (A)
using four of the provided screws (BB) .
- Gently rotate the cabinet (A) right side up .
- Place a carpenter's level on top of the cabinet, then adjust each
leveling foot until the cabinet is level .

INSTALLING THE DOOR HANDLES

- Insert the door handle screws (AA) into the pre-drilled holes on
each door .
- Attach the door handle (G) and hand tighten the door handle
screws (AA) . Do not overtighten .
- Repeat on other door .

DOOR POSITION ADJUSTMENT

If the doors need to be repositioned, the hinges can be adjusted to
ensure a precise fit with the cabinet.
1 . The lateral adjustment screw adjusts the door orientation from
left to right .
2 . The horizontal adjustment screw adjusts the door orientation
from front to back .
3 . The vertical adjustment screw adjusts the orientation
up or down .
QL105
BB
C
A
G
AA
6
2
1
3