Bosch MUM5X Serie Notice D'utilisation page 45

Cable length
Adjust the length of the power cable
to your needs.
Adjusting cable length via cable
rewinder
Pull the power cable out to the re-
1.
quired length and slowly let go.
To shorten the cable,
2.
pull the cable,
‒
allow the cable to wind up,
‒
pull the cable out again.
‒
Note: Do not push the cable in by
hand. If the cable jams, pull right out
and let it wind up again.
Moving the swivel arm
Press the release button and raise
1.
the swivel arm until it engages.
→ Fig.
4
a The swivel arm is fixed in posi-
tion 2.
Press the release button and move
2.
the swivel arm down until it en-
gages in the vertical position.
→ Fig.
5
a The swivel arm is fixed in posi-
tion 3.
Inserting bowl
Place the bowl in the base unit.
1.
→ Fig.
6
Use the recesses on the base unit.
Turn the bowl anticlockwise until it
2.
engages.
→ Fig.
7
Removing bowl
Turn the bowl clockwise and re-
▶
move.
→ Fig.
8
All manuals and user guides at all-guides.com
Inserting tools
Select the tool required.
1.
→ "Overview of tools", Page 43
Press the tool into the main drive
2.
until it engages.
→ Fig.
9
To insert the kneading hook:
3.
Insert the kneading hook with
‒
the protective cap fitted in the
main drive.
Turn the protective cap until the
‒
kneading hook engages fully.
→ Fig.
10
The protective cap
the main drive completely.
Removing tools
Pull the tool completely out of the
▶
drive.
→ Fig.
11
Attaching bowl lid
Requirements
¡ The required tool is used here.
¡ The bowl has been inserted.
¡ The swivel arm is closed.
Press the release button, raise the
1.
swivel arm slightly and hold in
place.
→ Fig.
12
Lift the lid slightly at the front, slide
2.
fully onto the bowl and set down.
→ Fig.
13
The filling shaft must face towards
the front.
Push the swivel arm down until it
3.
engages.
→ Fig.
14
Removing bowl lid
Press the release button, raise the
1.
swivel arm slightly and hold in
place.
Basic operation en
must cover
45