Intended Use; Additional Safety Rules - Panasonic EYFGA1AR Instructions D'utilisation

I

. INTENDED USE

This tool is a Cordless Screwdriver and can
be used to tighten bolts, nuts, and screws with
torque control. Additionally, the tool with the ra-
dio transmitter option can transmit an OK/NOK
signal to the Assembly Qualifiers.
IMPROPER USE
The use of the tool other than INTENDED USE
is dangerous and must be avoided.
The tool must not be used for the purposes
such as the following;
• to mix paint or building materials,
• polishing, grinding, sharpening, engraving.
RESIDUAL RISK
Some residual risks remains even with proper
use of the tool such as the following;
• contact with the rotating bit
• contact with the sharp edges of material or
something.
Read "the Safety Instructions" booklet
and the following before use.
II
. ADDITIONAL SAFETY
RULES
1) Wear ear protectors when using the
tool for extended periods.
) Be aware that this tool is always in an
operating condition, since it does not have
to be plugged into an electrical outlet.
3) Hold power tools by insulated gripping
surfaces when performing an operation
where the cutting tool may contact hid-
den wiring or its own cord.
Contact with a "live" wire will make exposed
metal parts of the tool "live" and shock the
operator.
4) Do NOT operate the Forward/Reverse
lever when the main switch is on. The bat-
tery will discharge rapidly and damage to
the unit may occur.
5) During charging, the charger may become
slightly warm. This is normal.
Do NOT charge the battery for a long period.
6) When storing or carrying the tool, set the
Forward/Reverse lever to the center posi-
tion (switch lock).
All manuals and user guides at all-guides.com
7) Do not strain the tool by holding the speed
III
Attaching or Removing Bit
1. Hold the collar of quick connect chuck and
. Insert the bit into the chuck. Release the
3. The collar will return to its original position
4. Pull the bit to make sure it does not come out.
5. To remove the bit, pull out the collar in the
- 9 -
control trigger halfway (speed control
mode) so that the motor stops.
Symbol
V
Direct current
n
No load speed
0
Revolutions or
... min
-1
reciprocations per minutes
Electrical capacity of battery
Ah
To reduce the risk of
injury, user must read and
understand instruction
Do not incinerate or heat
battery pack. Do not charge
or use under conditions of
high temperature. Do not ex-
pose to high temperatures.
Do not disassemble or
Do not expose to rain or
ASSEMBLY
.
NOTE:
• When attaching or removing a bit, discon-
nect battery pack from tool or place the
switch in the center position (switch lock).
pull it out from the tool.
collar.
when it is released.
same way.
EN
Meaning
Volts
pack
manual.
modify.
water.