Ugolini INSTANT 20/2 Carnet D'instructions page 14

INSTANT
IMPORTANT
The Smart Card reader works only when the dispenser is
in Standby mode.
.
The following message appears on the display when the
dispenser accepts the Smart Card:
CREDIT LOAD
YES
Press (OK) to transfer credit from the Smart Card to the
dispenser.
During normal operation, when awaiting commands, READY is
shown on the top line of the display while the residual credits of
the drinks are shown on the bottom line:
READY
980
5. 6 WATER FILTER
The dispenser has a water filter on the tank suction pipe. This
component descales the water, i.e. retains calcium in the water
used to prepare the drinks. It should be replaced after a certain
number of dispensing operations, otherwise it will lose its
descaling capacity and this can result in damage to the internal
parts of the dispenser. A filter lifespan counter can be set that
counts down with each dispensing operation and, when it
reaches zero, this message appears on the display:
REPLACE
WATER FILTER
To cancel this message and restore normal operation, you need
to replace the filter with a new one and then press the FILTER
RESET (4) key for five seconds.
figure 7
NO
90°C 740
6 CLEANING AND SANITIZING PROCEDURES
Cleaning and washing the appliance are vital to guarantee
perfect preservation of flavour of the drink and maximum
efficiency of your dispenser. The procedures described below
must be considered of a general nature and may vary owing to
the applicable health and safety regulations in force.
6. 1 DISASSEMBLY
ATTENTION
Before disassembling any component, always unplug
the device from the mains or turn off the external wall
switch.
1 Remove the drip tray and empty it.
2 Remove the dispensing nozzles.
3 Remove the front cover.
4 Remove the powder containers from the dispenser.
5 Disassemble the mixers as follows (see figure 8):
A Turn the steam suction collar clockwise to release the suction
pipe from its seat. Pull the powder collection funnel upwards to
release it from the mixing chamber and then pull it outwards to
remove it.
B Turn the body of the mixer to release it from its base and pull
it outwards to remove it.
C Remove the rotating part of the mixer releasing it from the
motor shaft.
D Turn the base assembly of the mixer to release it from the
retaining pins and pull it outwards to remove it.
14
figure 8