Description Of Controls - Ugolini INSTANT 20/2 Carnet D'instructions

INSTANT
provided connection slot (see figure 5).
IMPORTANT
Always use food-grade soluble freeze-dried granular
products.
5 Turn on the dispenser at the master switch (see paragraph

5. 2 DESCRIPTION OF CONTROLS).

6 Lower the front cover, the dispensing nozzles and the drip
tray following the procedure above in reverse order.
IMPORTANT
The dispenser must always be used with the covers of
the water tank and powder containers assembled, and
with the front cover and drip tray correctly installed, in
order to avoid contamination of the foodstuffs with
external agents.
5. 2 DESCRIPTION OF CONTROLS
There is a master switch on the upper half of the dispenser at
the front. This switch is used to switch the dispenser on and off.
The dispenser also has a capacitive keypad (see figure 6) the
functions of which are illustrated below:
figure 5
(1) Standby button : press it for 2 seconds to switch from Standby
mode to Ready mode and vice versa.
In configuration mode, press this key to confirm
the current selection and go to the next menu.
CONFIRM key (OK).
(2) Button to dispense : press to dispense the complete dose of the drink
complete dose of on the left hand side.
LH drink
In configuration mode, press this key to scroll up.
UP key ().
(3) Button to dispense : press to dispense half the dose of the drink on the
half dose of LH left hand side.
drink In configuration mode, press this key to scroll
down. DOWN key ()
(4) Button to dispense : press and hold to dispense only hot water from the
water from LH unit left hand unit.
In configuration mode, press this key to cancel the
selected option and return to the menu option
above. CANCEL key (C)
(5) Button to dispense : press to dispense the complete dose of the drink
complete dose of on the right hand side.
RH drink
(6) Button to dispense : press to dispense half the dose of the drink on the
half dose of RH right hand side.
drink
(7) Button to dispense : press and hold to dispense only hot water from the
water from RH unit right hand unit.
(8) Display if present, it shows in full all the alarm messages
managed by the dispenser.
(10) Smart Card reader : see chapter 5.5 USE OF THE SMART CARD
(OPTIONAL)
5. 3 USE THE DISPENSER
1 Prepare the dispenser as instructed previously (see
paragraph 5. 1 PREPARING THE DISPENSER).
2 Turn on the dispenser at the master switch. The display
shows the current software version and, at the end of the
starting cycle, the dispenser goes into standby and the OFF
message appears on the display:
COMPANY LOGO
In this mode, the dispenser is inactive, the water is not heated
and no dispensing can be carried out.
The only functions available when the dispenser is in standby
are loading of credit from a Smart Card (see chapter 5. 5 USE
OF THE SMART CARD (OPTIONAL)) and access to the
Configuration Menu (see paragraph 5. 5 SMART CARD
(OPTIONAL)).
12
figure 6