Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Operating instructions
This appliance can be operated by both remote control and manual button. Once the unit has been
properly connected to an earthed electrical outlet, turn on the main switch located on the left hand side of
the appliance. A beep should be heard when the power is first applied.
Operating by Manual Button
-
Manual on/off switch: This switch turns heater on/off, and permit/prohibits use of remote and
panel push buttons.
-
Flame button: By pressing the flame effect button the unit will cycle through three flames.
-
Heater button: Press once turns 1000W power on. Press again turns 2000W power on.
-
Thermostat setting: The knob is marked with numbers to indicate the maximum and minimum
temperature positions. Start with setting 9 and to decrease the temperature turn knob to left to a
lower setting. To increase the temperature, turn knob to right to a higher setting.
Operating by Remote Handset
-
Make sure the battery are installed properly in the remote control.
-
The effective range of the remote control is up to 4 meters or 13 feet.
-
Power On/Off button: Press once turns appliance on. Press again turns appliance off.
-
Flame effect button: The fire has three flame effects, by pressing the flame effect button the
unit will cycle through each effect.
-
High button: Press once turns 2000W heater on. Press again turns 2000W heater off.
-
Low button: Press once turns 1000W heater on. Press again turns 1000W heater off.
-
Back light button: The fire has three back light effects, by pressing the back light button the
unit will cycle through each effect.
ENG-5
Publicité
Table des Matières
