AEG FAVORIT 55010 VI Notice D'utilisation page 80

80
What to do if ...
Fault code and malfunction
• continuous flashing of the light of the run-
ning programme
• point-shaped optical signal is flashing
• intermitted audible signal
Anti-flood device is activated.
The programme does not start.
The flashing of the point-shaped optical signal on the floor beneath the dishwasher's door
will not be visible if the appliance has been installed higher up with a furniture door moun-
ted flush.
Once these checks have been carried out, switch on the appliance: the programme will
continue from the point at which it was interrupted.
If the malfunction or fault code reappears contact the Service Force Centre.
For other fault codes not described in the above chart, please contact your local Service
Force Centre, quoting the model (Mod.), product number (PNC) and serial number (S.N.).
This information can be found on the rating plate located on the side of the dishwasher
door.
So that you always have these numbers at hand, we recommend you to make a note of
them here:
Mod. : . . . . . . . . . . . . . . . . . . . . . . .
PNC :. . . . . . . . . . . . . . . . . . . . . . . .
S.N. : . . . . . . . . . . . . . . . . . . . . . . . .
Possible cause and solution
• Close the water tap and contact your local
Service Force Centre.
• The dishwasher's door has not been properly
closed. Close the door.
• The main plug is not plugged in. Insert the
main plug.
• The fuse has blown out in the household fuse
box.
Replace the fuse.
• Delay start has been set.
If dishes are to be washed immediately, cancel
the delay start.