Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
3. ID SET
Press the Up button on the remote control for 5 seconds.
• Until pairing is complete, the Multicolour LED changes as Red → Green → Blue in turn.
Remote Control Button
4. Check if the LINK LED is solid blue (connection complete).
Front of the Wireless Subwoofer
5. If the SWA-W500 is not connected, repeat the procedure from Step 2 through 4.
NOTES
– Do not connect the power cord of this product or your TV to a wall outlet until all connections
between components are complete.
– Before moving or installing this product, be sure to turn off the power and disconnect the power cord.
– The maximum transmission distance of the wireless signal of the main unit is about 10 m, but may
vary depending on your operating environment. If a steel-concrete or metallic wall is between the
main unit and the wireless subwoofer, the system may not operate at all, because the wireless
signal cannot penetrate metal.
PRECAUTIONS
– Wireless receiving antennas are built into the wireless subwoofer. Keep the units away from water
and moisture.
– For optimal listening performance, make sure that the area around the wireless subwoofer and
Wireless Receiver Module (Sold separately) is clear of any obstructions.
5 Sec
Stops blinking.
Glows blue.
ENG - 21
LED Indicator
→
→
Red
Green
Blue Blinks
Pairing
Cyan Blinks X3
Connection is complete
The LINK LED indicator stops blinking
and glows a solid blue when a
connection is established between the
Soundbar and the Wireless Subwoofer.
Publicité
Table des Matières
