Samsung HW-S50A Mode D'emploi page 13

Masquer les pouces Voir aussi pour HW-S50A:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles


(Sound Control)
By pressing the button, you can select the desired audio mode. The desired settings can be adjusted
using the Up/Down buttons. Each time the mode changes, the Multicolour LED blinks in white.
LED
Indicator
– To control the volume of the treble or bass sound, select "Treble", "Bass", "Sync", or "Centre Level" in
Sound Settings, and then adjust the volume between -6~+6 by using the Up/Down buttons.
7 Band EQ
Press and hold the
frequency band. 150Hz, 300Hz, 600Hz, 1.2kHz, 2.5kHz, 5kHz, and 10kHz are selectable using the Left/
Right buttons and each can be adjusted to a setting between -6 to +6 using the Up/Down buttons.
(Make sure the Sound mode is set to "Standard".)
Press and hold the
for about 5 seconds.
– To control the volume of the each speaker select "Centre Level" in Sound Settings, and then adjust
the volume between -6~+6 by using the Up/Down buttons.
– If the video on the TV and audio from the Soundbar are not synchronised, select "Sync" in Sound
Control, and then set the audio delay between 0~300 milliseconds by using the Up/Down buttons.
(Not available in "USB" or "Bluetooth"mode.)
– "Sync" is only supported for some functions.
White Blinks X1
"Treble"
"Bass"
"Sync"
(Sound Control) button for about 5 seconds to adjust the sound for each
5 Sec
(Sound Control) button
"150Hz"
PAIR
SOUND
MODE
VOL
WOOFER
"Centre Level"
7 Band EQ
Using the Left/Right buttos and each can be
adjusted to setting between -6 to+6.
"150Hz"
ENG - 13
"300Hz"
"600Hz"
"2.5kHz"
"5kHz"
"10kHz"
"1.2kHz"

Publicité

Table des Matières
loading

Table des Matières