Function Buttons - hajdu HB300 Manuel De Mise En Service, D'opération Et D'entretien

_________________________________ ___EN__________________________________26
heating to run over several heating cycles, press the E-heater button
once again.
6.6. How the Appliance Operates
When the appliance is switched off, press the
up. Using the
60℃), press the
the water in the tank to the desired temperature.
6.7.

Function buttons

E-heater
This mode can be set manually. If the E-heater is disabled, follow the steps below
to enable it.
 Press the 'E-HEATER' button; the icon '
 Press the 'ENTER' button to confirm that you want to activate electrical
heating in the appliance. With the assistance of the electrical heating, you
can already achieve the desired higher water temperature.
 Then, if necessary, re-activate the "E-heater" and repeat the steps.
 If E-heater is not active any more, pressing 'E-HEATER' again will make the
icon ' ' reappear on screen.
Switching between temperature units
 Press and hold down the 'E-HEATER' button for 10 seconds, then select the
desired temperature display format. You can switch from 'F' to 'C' or from 'C'
to 'F', in order to display the temperature in Celsius or Fahrenheit degrees
respectively.
 Default value: 'C'.
INCREASE/UP &
When the keylock is released, you can 'INCREASE' or 'DECREASE' the
selected value by pressing these keys.
 When setting the temperature, you can continuously increase (decrease) the
temperature value by continuously pressing the 'DOWN' ('UP') button for 1
second.
 When setting the clock/timer, you can continuously increase (decrease) the
All manuals and user guides at all-guides.com
buttons set the desired water temperature (between 38 and
button gombot, and the appliance will automatically heat up
DECREASE/DOWN
button. The appliance will power
' displays on the screen.