hajdu HB300 Manuel De Mise En Service, D'opération Et D'entretien page 54

____________________________________________EN________________________________________12
Figure 7.1.-2.
Figure 7.1.-4.
d)
The selected location must be ready to house a discharge opening for
condensate water connected to the upper part of the appliance with a flexible
circuit.
e)
Please ensure that
systems to which the appliance will be connected fully comply with all relevant
regulations.
f)
The selected location has to possess (or to be able to house) a single phase
230 V ~ 50 Hz external switch.
g)
According to the definitions of relevant regulations, the selected location has
to comply with IP protection class (protection against liquid penetration).
h)
Do not expose the appliance to sunlight, not even through any window.
i)
The appliance must not be exposed to effects of especially aggressive
materials, i.e. acidic gases, environment saturated by dust or gas.
j)
The appliance must not be mounted directly to phone line without overvoltage
protection.
k)
The appliance must be placed and operated as close to the usage points as
possible, in order to limit the diffusion of heat along the pipeline.
l)
Adequate electric power system, water pipeline and sewage system should
be ensured on the location of the operation. (floor drain).
m)
In order to reduce heat loss due to hot water pipe, please install the appliance
close to hot water usage locations, if possible. In case of larger distances, it is
All manuals and user guides at all-guides.com
the location of operation and electric and hydraulic
Figure 7.1.-3.
Figure 7.1.-5.