What To Do If; Technical Data - Zanussi ZEL63 Notice D'utilisation

The stainless steel can become tarnished if it is too
much heated. Refer to this you must not cook with pot-
stones, earthenware pans or cast iron plates. Do not use
aluminium foil to prevent damage the top during opera-
tion.
Stainless steel parts wash with water, and then dry with
a soft cloth.
Scratches or dark stains have no effect on how the
appliance operates.
Removing the dirt:
1. Use the fine scouring powder or a scouring pad to
remove the dirt.

What to do if...

Problem
The appliance does not operate.
The plate does not heat up.
Results of plate are not satisfactory.
If there is a fault, first try to find a solution to the prob-
lem yourself. If you cannot find a solution to the prob-
lem yourself, speak your dealer or the local Service
Force Centre.
If you operated the appliance incorrectly, or the in-
stallation was not carried out by a registered engi-
neer, the visit from the customer service technician or
dealer may not take place free of charge, even during
the warranty period.

Technical data

Hob dimensions
Width:
14
All manuals and user guides at all-guides.com
• Start the appliance again and set the heat setting in 10 seconds.
• Examine the fuse in the electrical system of the house in the fuse box.
If the fuses blow time after time, speak to an authorised electrician.
• Make sure that you plug in the appliance and switch the electrical supply.
• Make sure that you turn correct control knob.
• Examine the fuse in the electrical system of the house in the fuse box.
If the fuses blow time after time, speak to an authorised electrician.
• Make sure that plate is clean and dry.
• Make sure that the cooking pan is the correct size for the plate.
• Make sure that cooking pan has a flat bottom.
• Make sure that the setting is correct for type of cooking.
580 mm
2. Clean the appliance with a damp cloth and some de-
tergent.
3. Heat the hotplate to a low temperature and leave to
dry.
4. To maintain the hotplates, rub in a little sewing ma-
chine oil now and again and then polish off with ab-
sorbent paper.
Important! For stainless steel edges of the hob use
cleaner for stainless steel.
The stainless steel edge of the plate can be slight-
ly discoloured as a result of the thermal load.
Possible cause and remedy
These data are necessary to help you quickly and cor-
rectly. These data are available on the identification
plate from the injectors kit.
• Model description .................
• Product number (PNC) .................
• Serial Number (S.N.) .................
Use the original spare parts only. They are available at
Service Force Centre and approved spare parts shops.
Length: 500 mm