Cooling Fan - Hamilton Beach Commercial HVS400 Mode D'emploi

PROTECTIVE TAPE
There are two (2) factory-installed
strips of seal bar tape on the vacuum sealer.
DO NOT REMOVE THE TAPE!
10 MM UPPER
SEAL BAR TAPE
15 MM LOWER
SEAL BAR TAPE
The Seal Bar Heating Element and Vacuum Lid Seal are each covered with
Seal Bar Tape to protect vacuum bags during sealing (FIGURE 1). DO NOT
remove the Seal Bar Tape. See the "Service Instructions" on page 10 for
information on replacing the Seal Bar Tape, if necessary.
NOTE: One extra 15 MM Seal Bar Tape is included.
VACUUM CHAMBER SEALS
There are two factory-installed Oval Vacuum Chamber Seals on the Vacuum
Sealer. When the Vacuum Lid is closed and downward force applied, they
form an airtight seal so the Vacuum Chamber can be evacuated.
The Oval Vacuum Chamber Seals may wear over time and require
replacement. See the "Service Instructions" on page 10 for information on
replacing the Oval Vacuum Chamber Seals, if necessary.

COOLING FAN

The Vacuum Sealer has an Internal Cooling Fan that runs whenever the unit
is plugged in and turned on. To save energy, turn the unit "OFF" ( ) and
unplug the Power Cord when not in use.
6
OVAL VACUUM CHAMBER SEALS
DO NOT REMOVE!
FIGURE 1