Cleaning Instructions - Hamilton Beach Commercial HVS400 Mode D'emploi

TROUBLESHOOTING
w WARNING Electrical Shock Hazard. Before assembling or
disassembling the Vacuum Sealer, make sure the Vacuum Sealer is OFF ( )
and the plug is removed from the outlet/power source.
If the Vacuum Sealer does not operate when it is plugged
in and turned on, try any or all of the following:
1. Make sure the Fuse is not blown. The Fuse is located
on the right side of the unit directly above the Power
Cord Port. Turn "OFF" ( ) and unplug the Vacuum
Sealer. Twist off and remove the Fuse Cap. Remove
and check the Fuse. The thin metal band in the
center of the Fuse should be clean and unbroken.
Only replace fuse with a 10-ampere cartridge fuse.
Replace the Fuse Cap.
2. Make sure the Connector at the end of the Power
Cord is plugged completely into the Power Cord Port.
3. Make sure the Power Cord is not damaged. DO NOT
use a damaged Power Cord. Call Customer Service
for information on part replacement.
4. Try connecting the Power Cord Plug to another
electrical outlet.

CLEANING INSTRUCTIONS

w WARNING Electrical Shock Hazard. Before cleaning the Vacuum
Sealer, make sure the Vacuum Sealer is OFF ( ) and the plug is removed from
the outlet/power source.
w CAUTION Burn Hazard. The Seal Bar and Vacuum Chamber Seal get hot
and can cause burns. Avoid contact. Allow Vacuum Sealer to cool for 20 minutes
before cleaning.
•
NEVER IMMERSE the Vacuum Sealer in water or other liquid.
•
Wipe all outside surfaces including the plastic Vacuum Chamber and
Vacuum Lid with a damp cloth or paper towel. Avoid spraying cleaner or
any other liquid directly into the vent on the left side of the unit. DO NOT
use abrasive cleansers! Abrasive cleansers will spoil the clarity of the
Vacuum Lid.
•
Avoid peeling or damaging the Seal Bar Tapes.
•
Dry all surfaces and close the Vacuum Lid before storing the Vacuum
Sealer.
11