Select Location - Honeywell F200 Mode D'emploi

F200 CHARGED-MEDIA AIR CLEANER

Select Location

The RF AIRWATCH can be mounted in any convenient
location in the home.
1. Select the desired location (at least six feet away from
transmitter in door).
2. Check for communication between the F200 Media Air
Cleaner and the AIRWATCH® Indicator as follows:
a. Place the AIRWATCH® Indicator in the desired
mounting location. Use a piece of masking tape to
hold the device to the wall.
b. At the F200, press the reset button on the door.
c. Verify that the arrows on the AIRWATCH® Indicator
are flashing. (The arrows will flash for about two min-
utes before returning to normal.)
3. If there is no response on the AIRWATCH® Indicator,
choose another location within the home and begin
again at step 2.
Mount AIRWATCH® Indicator
1. Remove the AIRWATCH® Indicator from the base:
a. Depress the tab on the bottom edge of the base.
b. Pull off the bottom of the front cover.
2. Position the base on the wall in the desired mounting
position; using the holes in the base as a template, mark
the locations for the anchors and screws provided.
3. Drill holes (3/16in.) and install the screw anchors pro-
vided.
4. Position the base over the holes and install the screws
provided; tighten the screws until the base is mounted
firmly to the wall.
5. Reinstall AIRWATCH® Indicator onto base:
a. Hook the top.
b. Snap the bottom into place.
Initialize the AIRWATCH® Indicator to
accept signals from the F200 transmitter:
1. Be sure the RF AIRWATCH® receiver is at least six feet
away from the transmitter in the door to ensure commu-
nication.
2. Push and hold the AIRWATCH® Indicator button until all
four arrows come on (about five seconds).
3. Push the red reset button on the F200 door within two
minutes.
4. Observe the indicator arrows on the RF AIRWATCH®
begin to flash and continue for about two minutes until
initialization is completed.
68-0238EF—04
The AIRWATCH® Indicator default setting is UV Light and
Humidifier timers are disabled; the Filter indicator is always
enabled. To display active timers:
1. Press and hold the button on the AIRWATCH® Indicator
for about three seconds.
2. Observe the arrow showing the active timer(s).
To activate a timer:
1. Press and release the AIRWATCH® Indicator button until
the desired device is selected, as indicated with the
flashing arrow.
2. Press and hold the button until the arrow stops flashing.
3. Release the button while the arrow is on.
To deactivate a timer:
1. Press and release the AIRWATCH® Indicator button until
the desired device is selected, as indicated with the
flashing arrow.
2. Press and hold the button until the arrow turns off (about
four seconds).
3. Release the button while the arrow is off.
AIRWATCH® Indicator Operation
The Indicator has an LCD with four indicator segments: On/
Battery, Air Cleaner, UV Air Treatment and Humidifier. See
Table 1.
Checkout
Visually check the installation. Make sure:
• Airflow is in the direction of the arrow on the media air filter
cartridge.
• Turning vanes and transitions, if used, are properly
installed.
• Joints in sheetmetal between media air filter and furnace
are sealed.
• All sheetmetal connections are complete.
• Original furnace filter has been removed and blower
compartment is cleaned.
Replace any access doors removed during the Installation or
Checkout.
Run the furnace or cooling system through one complete cycle
to make sure the system operates as desired.
8