Operating Mode Auto - Nibe RMU 40 Manuel Installateur

Change the operating mode by marking the desired mode
and pressing the OK button. To select selectable functions
that are permitted or not, mark the function using the
arrow buttons and press the OK button.

Operating mode auto

In this operating mode you cannot select which functions
are to be permitted because it is handled automatically
by the heat pump/indoor module.
Operating mode manual
In this operating mode you can select what functions are
permitted.
Operating mode add. heat only
Caution
If you choose mode "add. heat only" the com-
pressor is deselected and there is a higher oper-
ating cost.
In this operating mode the compressor in the heat pump
is not active and only additional heat is used.
Functions
"addition" is what helps the compressor to heat the
accommodation and/or the hot water when it cannot
manage the whole requirement alone.
"heating" means that you get heat in the accommoda-
tion. You can deselect the function when you do not
wish to have heating running.
"cooling" means that you get cooling in the accommod-
ation in hot weather. You can deselect the function when
you do not wish to have the cooling running. This altern-
ative requires an accessory for cooling or if the heat pump
has a built in function for cooling.
Menu 5 - SERVICE
Here you set which climate system the room unit should
be connected to. Confirm the setting using the OK but-
ton.
The menu displays which product is connected, and the
software version in RMU 40.
Caution
The climate system must also be activated in the
heat pump/indoor module menu 5.2. Activate
all climate systems you wish to control from
RMU 40.
Manage alarm
In the event of an alarm a symbol is shown at the top
edge of the display together with the alarm's number.
Go to the heat pump/indoor module to get more inform-
ation.
In the other menus the alarm symbol is shown in the
bottom right hand corner.
GB
21