Belt Installation, Adjustment And Replacement - Bercomac Limitee 700374-1 Manuel Du Propriétaire

BELT INSTALLATION,
AND REPLACEMENT:
SNOWBLOWER BELT:
a) Lower the snowblower to the ground.
b) Remove the belt guard.
c) Loosen the knob (item 10) of the bearing support
(item 11).
d) Install the belt as shown.
e) Adjust the ball bearing support (bracket) (item 11)
on the belt. Push on the bearing (item 12) to
apply a slight pressure on the back of the belt
(just enough to hold the belt in place). It is normal
that the bearing is off centre (towards the back of
the snowblower) on the pulley. Just make sure
that it does not come into contact with the wall of
the pulley.
Tighten firmly with the knob (item 10).
MAINTENANCE
ADJUSTMENT,
11
Item 1: Snowblower pulley
Item 2: V pulley
Item 3: Tension arm
Item 4: Flat pulley
Item 5: Drive mechanism pulley
Item 6: Flat pulley
Item 7: Engine pulley
Item 8: Snowblower belt
Item 9: Drive mechanism belt
Belt installation
Position the bearing support