Belt Installation, Adjustment And Replacement - Bercomac Limitee 700374 Manuel Du Propriétaire

Table des Matières

Publicité

BELT
INSTALLATION,
AND REPLACEMENT:
SNOWBLOWER BELT:
a) Lower the snowblower to the ground.
b) Install the belt as shown.
c) Apply tension to the belt by pulling up the tension
arm (item 1).
After installation of the snowblower belt, make sure
there is enough tension on the belt. To obtain the
proper tension, the distance between the coils of
the spring should be .25'' (1/4'') approx.
If not, remove the bolt, sleeve and the spring (item
3) from the original hole and reinstall them in the
second hole (item 2). This will apply more tension
on the belt helping to prevent it from slipping in the
pulleys.
d)Engage the snowblower for a few seconds under
supervision. Stop the engine. Inspect the belt to
make sure it does not interfere with any parts; that it
is well inserted in the pulleys and that it has not
flipped on it's side while still on the pulleys. The V
of the belt (A) must be in the V of the pulley (B).
The back of the belt (C) must rest on the flat pulley
(D).
e)Use genuine belts only, they are specifically
fabricated for this application.
f) Reinstall the belt guard.
g)To know the belt identification, please refer to the
subframe manual.
NOTE: Belts must be under high tension at all times.
If spring is damaged or stretched, you must replace
DRIVE MECHANISM BELT:
See
subframe
manual
instructions.
Belt Insertion
MAINTENANCE
ADJUSTMENT,
it
for
belt
replacement
CAUTION
The belt tension and lift assist spring arm are
spring loaded & need to be held firmly while
displacing to prevent injury
Distance between coils
11
.
Belt installation
Tension adjustment

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

700378

Table des Matières