Table des Matières
Publicité
STEP 2
SNOWBLOWER INSTALLATION:
Refer
to
parts
breakdown
identification.
WARNING
TO PREVENT INJURIES:
Stop the motor.
Apply parking brake.
Remove the ignition key.
Disconnect the wire from the spark plug(s) and
keep away from spark plug(s) to prevent accidental
starting.
Attach the snowblower to the subframe as shown.
Make sure the snowblower is pushed in until locked
into place by the springs (item 3).
Lift the snowblower.
Turn the tension arm (item 1) towards the back and
install the chain (item 2) on the hook (if subframe is
equipped with one)
Turn the tension arm towards the front to apply
tension on the spring.
Lower the snowblower.
CAUTION
The belt tension and lift assist spring arm are spring
loaded & need to be held firmly while displacing to
.
prevent injury
Remove the belt guard.
Install the belt on the pulleys as shown.
Install the belt on the drive mechanism pulley (item 5)
under the tractor.
NOTE: See belt instructions in the Maintenance
section.
Apply tension on the belt by pulling up the belt tension
arm.
Reinstall the belt guard.
CAUTION
Never use the snowblower without the belt guard.
ASSEMBLY
section
for
parts
7
Install snowblower and lift assist spring
Item 1: Snowblower pulley
Item 2: V pulley
Item 3: Tension arm
Item 4: Flat pulley
Item 5: Drive mechanism pulley
Item 6: Flat pulley
Install belt
Publicité
Table des Matières
