Bercomac Limitee 700374 Manuel Du Propriétaire page 10

VERIFY BELT ROUTING:
-Lower the snowblower to the ground and let it run for
a few seconds under supervision.
-Disengage the snowblower and stop the engine.
-Remove the belt guard.
-Check the belts to make sure they are well inserted
in the pulleys and that they have not flipped on their
sides on the pulleys and that they do not touch the
belt guides.
-Reinstall the belt-guard.
7
WARNING
TO PREVENT INJURIES:
It is the person who installs the drive mechanism
responsibility to make sure that when the clutch
is disengaged that all moving parts stop.
For more information, do not hesitate to contact
the technical support.
Insert the handgrip (item 1) on the handle as shown.
Insert the handle hook (item 2) into the handle and
secure with a 2.5 mm hair pin (item 3) as shown.
VERIFY SKID SHOE ADJUSTMENT:
LEVEL PAVED SURFACE: Adjust skid shoes to
allow 3/16" to 1/4" clearance (A) between cutting
edge and surface.
UNEVEN OR GRAVEL SURFACE: Adjust skid
shoes to allow 1/2" to 5/8" clearance (A) between
cutting edge and surface.
VERIFY TIRE PRESSURE:
Check and adjust tractor tire pressure as follows:
Front tires:
Back tires:
Tire pressure must be even on both sides of tractor.
ASSEMBLY
7
14-15 psi
7-8 psi
8
Install handle
Adjust skid shoes