Table des Matières
Publicité
STEP 2
SNOWBLOWER INSTALLATION:
Refer
to
parts
breakdown
identification.
WARNING
TO PREVENT INJURIES:
Stop the motor.
Apply parking brake.
Remove the ignition key.
Disconnect the wire from the spark plug(s) and
keep away from spark plug(s) to prevent accidental
starting.
Attach the snowblower to the subframe as shown.
Make sure the snowblower is pushed in until locked
into place by the springs (item 3).
Lift the snowblower.
Turn the tension arm (item 1) towards the back and
install the chain (item 2) on the hook (if subframe is
equipped with one)
Turn the tension arm towards the front to apply
tension on the spring.
Lower the snowblower.
CAUTION
The belt tension and lift assist spring arm are
spring loaded & need to be held firmly while
displacing to prevent injury
NOTE: See belt installation instructions in the
Maintenance section.
CAUTION
Never use the snowblower without the belt guard.
ASSEMBLY
section
for
parts
.
Install snowblower and lift assist spring
WARNING
TO PREVENT INJURIES:
It is the person who installs the drive mechanism
responsibility to make sure that when the clutch
is disengaged that all moving parts stop.
For more information, do not hesitate to contact
the technical support.
7
Publicité
Table des Matières
