Time And Date Settings; Alarm Settings; Language Settings - PERFECTPRO ROCK-SOLID Manuel De L'utilisateur

TIME AND DATE SETTINGS

1. The displayed clock will automatically synchronize with the time and date of a RDS
radio station (if available, please see "RDS station service").
2. To manually set the time and date, turn off the device by pressing the On/Off
button.
3. Press and hold the Tuning knob for about 12 seconds, until the clock flashes in the
display.
4. Rotate the Tuning knob to adjust the data and then press the Tuning knob to
confirm each part of the required time and date.
5. Select and confirm "Synclock On" when you want the time and date to be updated
by the RDS signal. Select and confirm "Synclock Off" when you want to disable the
time and date to be updated by the RDS signal and keep your own manually set
time and date.
Note: When disconnecting the device from AC power the time setting will be lost and will
have to be picked up again from the RDS signal the next time the device is used again
in FM Radio mode. Menu settings and station presets are stored in the internal memory
and are not lost when the device is disconnected from AC power.
9
All manuals and user guides at all-guides.com

ALARM SETTINGS

The alarm settings can only be changed when the device is off (in standby mode). If no
buttons are pressed for 5 seconds, the device will exit the alarm setup menu and the
settings are cancelled.
Setting the alarm time (only possible in standby mode)
1. Press the Menu button once and rotate the Tuning knob until the display shows
"Alarm Set".
2. Press the Tuning knob to enter and the hour digits flash on the display.
3. Rotate the Tuning knob to set alarm hours.
4. Press the Tuning knob to confirm. The minute digits flash.
5. Rotate the Tuning knob to set alarm minute.
6. Press the Tuning knob to confirm.
7. The display will then show "Alarm Source". You may choose either "Buzzer" or "FM
Radio". Rotate Tuning knob to select. If "FM Radio" is selected, the last listened
station will be played when the alarm rings.
8. The display will then show "Alarm Volume". Rotate the Volume knob to set the
alarm volume.
9. Press Tuning knob to confirm.
10. The alarm icon (a bell shape) will be shown on the display, left next to the time.
Switching on/off the alarm (only possible in standby mode)
1. To switch the alarm on, press and hold the Info button and the alarm icon (a bell
shape) will be shown on the display, left next to the time.
To switch it off, press and hold the Info button again.
2. To turn off the alarm when it buzzes, simply press the On/Off button.

LANGUAGE SETTINGS

You can adjust the language setting by pressing the Menu button and then pressing the
Tuning knob when "Language" is shown on the Display. Next rotate the Tuning knob
to cycle through the choice of languages and press the Tuning knob to select your
language of choice.
GB
G B
10