3.1. Installing the DAB+ antenna
1.
Use a damp cloth to clean the windscreen.
Stick the black L-shaped copper film to the A-pillar (without
2.
trim) of the vehicle.
Attention: Do not remove the A-pillar if it has an Airbag!
Remove the adhesive protective film of the antenna amplifier
3.
and stick it to the intended position on the windscreen.
Now stick on the film antenna. Remove air bubbles by
4.
applying light pressure to the edge.
The antenna should be mounted vertically and not
5.
horizontally.
Route the antenna cable along the A-pillar up to where the
6.
DR 56+ is to be installed.
Do not attach the DAB antenna over heating wires, at a
7.
location where the driver's view is impaired, or in a place
where the windscreen is metallized (sun protection). This
could adversely affect the reception.
27