NTI Tft60-85 Installation Et Fonctionnement page 80

Trinity Tft
Tableau 16-3 "Hold and Lockout Codes"
Code Description
224 Invalid DHW demand source setting
225 Invalid Flame threshold setting
226 Invalid Outlet high limit set point setting
227 Invalid DHW high limit set point setting
228 Invalid Stack limit set point setting
229 Invalid Modulation output setting
230 Invalid CH demand source setting
231 Invalid Delta T limit delay setting
232 Invalid Pressure sensor type setting
233 Invalid IAS closed response setting
234 Invalid Outlet high limit enable setting
235 Invalid Outlet connector type setting
236 Invalid Inlet connector type setting
237 Invalid DHW connector type setting
238 Invalid Stack connector type setting
239 Invalid Header connector type setting
240 Invalid Outdoor connector type setting
241 Exchanger sensor not allowed with stack connector setting
242 Invalid DHW auto detect configuration
Invalid UV with spark interference not compatible with Igniter on throughout
243
PFEP
244 Internal fault: Safety relay test invalid state
245 Invalid Outlet connector type setting for T-rise
246 4-20mA cannot be used for both modulation and setpoint control
247 Invalid ILK bounce detection enable
248 Invalid forced recycle interval
249 STAT cannot be demand source when Remote Stat is enabled
250 Invalid Fan speed error response
251 Lead drop-stage on error setting does not match drop method configuration
252 Invalid Line frequency setting
253 Lead Lag modulation sensor not valid with setpoint source
254 Lead Lag modulation sensor not valid with local setpoint source
255 Lead Lag modulation sensor not valid with local modulation source
256 Selected Controller interaction enable setting is not allowed
257 Controller interaction enable does not match neighbor stack fault setting
258 Controller ID must be non-zero if controller interaction is enabled
259 Modulation output must be fan if controller interaction is enabled
260 Asymmetrical paired (no flap) is set but flap switch input is energized
261 Neighbor burner control blower fault detected
262 Blower fault detected during flap test
263 Invalid DHW demand temperature setting
264 Invalid preferred outlet high limit setting
265 Invalid preferred lightoff rate setting
266 Invalid preferred stack limit rate setting
80
Installation et fonctionnement
Note
Lockout
Lockout
Lockout
Lockout
Lockout
Lockout
Lockout
Lockout
Lockout
Lockout
Lockout
Lockout
Lockout
Lockout
Lockout
Lockout
Lockout
Lockout
Lockout
Lockout
Lockout
Lockout
Lockout
Lockout
Lockout
Lockout
Lockout
Lockout
Lockout
Lockout
Lockout
Lockout
Lockout
Lockout
Lockout
Lockout
Lockout
Lockout
Lockout
Lockout
Lockout
Lockout
Lockout