Victron energy 12/3000/120-16/230/240V Manuel page 18

5.3 Configuration by computer
All settings can be changed by means of a computer or with a VE.Net panel (except for the multi-functional relay and the VirtualSwitch
when using VE.Net).
The most common settings (including parallel and 3-phase operation) can be changed by means of DIP switches (see Section 5.5).
For changing settings with the computer, the following is required:
VEConfigureII software: can be downloaded free of charge at www.victronenergy.com.
•
A RJ45 UTP cable and the MK2.2b RS485-to-RS232 interface. If the computer has no RS232 connection, but does have USB, a
•
RS232-to-USB interface cable is needed. Both are available from Victron Energy.
5.3.1 VE.Bus Quick Configure Setup
VE.Bus Quick Configure Setup is a software program with which systems with a maximum of three Multi's (parallel or three phase
operation) can be configured in a simple manner. VEConfigureII forms part of this program.
The software can be downloaded free of charge at www.victronenergy.com .
For connection to the computer, a RJ45 UTP cable and the MK2.2b RS485-to-RS232 interface is required.
If the computer has no RS232 connection, but does have USB, a RS232-to-USB interface cable is needed. Both are available from
Victron Energy.
5.3.2 VE.Bus System Configurator
For configuring advanced applications and/or systems with four or more Multi's, VE.Bus System Configurator software must be used.
The software can be downloaded free of charge at www.victronenergy.com . VEConfigureII forms part of this program.
For connection to the computer, a RJ45 UTP cable and the MK2.2b RS485-to-RS232 interface is required.
If the computer has no RS232 connection, but does have USB, a RS232-to-USB interface cable is needed. Both are available from
Victron Energy.
5.4 Configuration with a VE.Net panel
To this end, a VE.Net panel and the VE.Net to VE.Bus converter is required.
With VE.Net all parameters are accessible, with the exception of the multi-functional relay and the VirtualSwitch.
14