Before Initial Use; Operation - tepro Albertville Mode D'emploi

C. According to the
arrow indicate, put the
screw into steel pipe
and tighten it with but-
terfly screw nut.
C
D. According to the
arrow indicate, plug in
slip feet cover.
D
2. Using some pressure, fit the grill
trough (14) onto the upper end of
the legs (10). Confirm that the legs
and the grill trough are connected
securely to each other.
3. Hook the wind/splash protection (2)
first into the two center recesses and
then into the left and right recesses.
4. Insert the hot plate (1) into the two
holes in the wind/splash protection
(2), and let the two rods on the side
of the hot plate (1) slide into the
provided notches on the left and the
right.
5. ATTENTION: The grill plate is placed
loosely above the heating coil to
prevent a buildup of heat.
Note:
When the legs are not installed, the grill
can be used as a table-top grill.
Take care to use a level, fire-resistant
base

Before Initial Use

1. Clean the grill grate and the drip
pan as described in the section
Maintenance and Cleaning.
GB
2. Set the appliance onto a level, dry,
and non-slip surface.
3. Use a heat-resistant base when the
appliance is used as a table-top grill.
4. Let the appliance heat for approx. 10
min without food in order to burn off
production residues.
5. Some smoke and corresponding
smell may occur with initial use.
This is normal and is caused by the
combustion of production residues.
The smoke and the smell disappear
after a short time. Please insure
sufficient ventilation of the room.
6. The appliance is ready for operation

Operation

1. Remove the grill grate (3). Then
remove the temperature control (6)
up from the grill support (14), and
then pull it back with the heating
element (4) and remove it.
2. Approx. 1 liter of cold water can
be poured into the drip pan (8) to
prevent excessive smoke while
grilling.
3. Refill water if the water level drops
while grilling. At this time, take care
that no water gets onto the heating
element.
4. Fit the heating element and the
temperature control back onto
the grill support by following the
steps in reverse. When doing so,
it is important that the temperature
control is fitted correctly into the
recess (13) of the grill holder (14).
The safety switch (brown) must be
pushed in completely. Otherwise the
appliance cannot be switched on.
29