Chicco STYLE GO UP Mode D'emploi page 13

• The product must only be assem-
n-
bled by an adult.
g
• To avoid all risks of strangulation,
never give children objects with
he cords or strings attached, or leave
them in the vicinity of such objects.
d • Never use the stroller on staircases
or escalators: you could suddenly
he
lose control of it.
• Always pay attention when going up
s-
and down steps or along the road.
• If the stroller is left exposed to direct
le
sunlight for a long time, allow it to
he
cool down before placing your child
he
inside. Prolonged exposure to direct
sunlight may cause the colour of
d
the materials and fabric to fade.
• Prevent the stroller from coming
e-
into contact with salty water as this
ot
may cause rusting.
n-
• Do not use the stroller on the beach.
• When not in use, the stroller should
ts
be kept out of reach of children.
n
TIPS FOR CLEANING AND MAINTENANCE
ot
This product requires periodical maintenance. Cleaning and
maintenance operations must be performed exclusively by an
ur
adult.
d
CLEANING
y,
Clean the fabric parts using a wet sponge and neutral soap.
The lining can be removed (please refer to the section "Fitting/
removing the seat lining"). Please refer to the care labels for in-
he
structions on how to clean the fabric parts. Below are the clean-
ing symbols and their meanings:
ve
s-
Wash by hand in cold water
se
Do not bleach
C
Do not tumble dry
n-
he
Do not iron
ct
Do not dry clean
Routinely wipe clean plastic parts with a soft damp cloth. Never
he
use solvents or abrasive detergents. To prevent the formation
of rust, always dry metal parts if they have come into contact
with water.
by
MAINTENANCE
Regularly check the condition of the wheels and clean off all
dust and sand. To avoid friction that may compromise the cor-
rect functioning of the stroller, make sure that all plastic parts
are clean of dust, dirt and sand. Keep the stroller in a dry place.
If necessary, lubricate the moving parts with dry silicone lubri-
cant.
LIST OF COMPONENTS
Check that none of the components of this model are missing
before assembling the product. If any part is missing, contact
Chicco Customer Service.
No tools are needed to assemble this product. The following
pieces are needed to assemble the product:
• Frame
• Seat
• Seat lining
• Hood
• Bumper bar
• Comfort kit (shoulder and crotch straps)
• Storage basket
• Bag
• Leg cover
• Rain cover
• 2 rear wheels
• 2 front wheels
ASSEMBLING THE STROLLER
1. Slide button A in the direction indicated and then press but-
ton B (fig 1); at the same time to extend the structure until
you hear the locking click (fig. 1A-1B).
2. Insert the front wheel in the dedicated hole until you hear
the locking click (fig. 2). Repeat the same operation for the
second front wheel.
WARNING: The front wheels have two different symbols: a cir-
cle and a square. The symbols are repeated on the lower part of
the front leg tube and indicate the correct correspondence of
the parts to be assembled. (fig. 2A-2B).
Pay close attention when carrying out these operations as the
wheel lock will not work if they are inverted.
3. To assemble the rear wheels insert the wheel pin in the rear
leg tube (fig. 3). Repeat the same operation for the other
wheel.
To remove the front and rear wheels press the release mecha-
nisms in figures 3A-3B.
WARNING: Before using the stroller, make sure that the wheels
are firmly attached to the structure by pulling gently outwards.
WARNING: When carrying out this operation make sure that
your child and other children are at a safe distance. Make sure
that during these operations the moving parts of the stroller do
not come into contact with your child.
BASKET
The stroller is equipped with a spacious basket.
4. To attach the basket to the stroller, insert the fabric strips in
the slots under the platform and on the front legs and fasten
the button (fig. 4-4A). Repeat this operation on the other side.
Finish assembling the basket by attaching the fabric cover to
the back of the tube using the dedicated buttons. (fig. 4B). To
make the basket easier to use there is a zip opening at the
back (fig. 4C).
WARNING: Do not let your child climb onto the storage bas-
ket: it could break, injuring them and overturning the stroller.
FITTING/REMOVING THE SEAT LINING
5. The lining must be fitted with the seat disengaged from the
stroller; before starting, open the waist buckle shown in fig. 5.
6. Fit the lining to the backrest (fig. 6) and insert the waist strap
in the relevant slots on both sides of the lower part of the
backrest (fig. 6A). Then insert the crotch strap in the slot in
the seat (fig. 6B).
13