Hendi 272404 Mode D'emploi page 11

Operating instructions
Before first use and after every gas cylinder change, gas delivery system must be purged of air before
igniting! To do this, turn the control knob anti-clockwise to the pilot setting. Press knob in and hold for 3
minutes before attempting ignition.
Battery replacment
Remove impulse ignition cap from Burner Assembly
(J) by turning cap counterclockwise. Install 1 AAA
battery. Negative end of battery goes in first, then
To light the pilot
• Check all connections prior to each use.
• Turn on main gas supply at source.
• Press to turn control knob anti-clockwise to
PILOT, see right photo.
• Hold knob depressed, press IGNITION button re-
peatedly until pilot flame is lit, then continue to
hold the knob depressed for 10 seconds until the
pilot remains it after releasing knob.
• If pilot fails to ignite or alight, press to turn knob
clockwise to OFF and repeat.
To light the patio heater
• The pilot should be lit and the knob set to PILOT.
• Hold knob depressed gently and turn anti-clock-
wise to LOW.
• When mesh glows lit, turn knob clockwise from
Low to HIGH as needed.
Re-lighting
• Turn Control Knob to OFF.
• Wait at least 5 minutes, to let gas dissipate, before
attempting to re-light pilot.
To extinguish
• Hold knob depressed & turn the knob clockwise
to 'OFF'
• Close the valve of the gas cylinder or the regulator
after use.
• Close the gas bottle and allow this appliance to
cool before moving the appliance.
All manuals and user guides at all-guides.com
replace impulse ignition cap by turning cap clock-
wise.
Note: The burner may be noisy when initially
turned on. To eliminate excessive noise from the
burner, turn the control knob to the pilot position.
Then turn the knob to the level of heat desired.
• Repeat the "Lighting" steps.
Note: After use, some discoloration of the emitter
screen is normal. Close regulator after use, allow
the appliance to cool before moving.
EN
11